I have a question that concerns the pre-configuration required for PXE booting on Alix 2d3.
Basically, what I have tried so far is, after installing dnsmasq, adjusting the configuration file /etc/dnsmasq.conf, where I simply uncommented the following commands:
dhcp-range=192.168.1.50,192.168.1.150,12h (I adjusted the addresses accordingly)
Following that, I put the ramfs image file (OpenWRT image that I built previously) in /tftpboot.
However, when I try to boot, I get no options to boot with PXE (I did press N after connecting Alix), the board simply loads what's on the CF card. When the card is removed, then nothing happens.
Is there some part of configuration that I am missing here?
This is the tutorial that I was referring to for the most part:
Thank you for your input.