I followed this guide:
Install from USB Stick to HDD connected to the Sata port.
And made a Installation with standard options.
During Installation the USB Stick is /dev/sda and the hdd is /dev/sdb.
When I install just grub, the boot fails. If I install the lilo Bootloader I end up in an initramfs because after reboot the HDD is /dev/sda and not /dev/sdb like during installation, it doenst matter if I leave the USB Stick connected.
When I "ln dev/sda1 /dev/sdb1" in the initramfs the system boots up. Fstab has only the UUID as identifier. Changing the /etc/lilo.conf file from sdb to sda ends up in booting errors that the disk identified "by-id" is missing.
Where is the config file or what is the right command to fix that issue?
Thanks in advance